How to set up ur Arbitrum wallet and bridging from ETH ( layer 1) to AETH (layer 2)
A thread 🧵 🪡
So at this point I believe everyone reading this thread already has a met@mask wallet, and has some ETH in it .
So firstly u need to set up ur wallet to Arbitrum (layer 2)
Steps to take
~open ur met@mask
~ tap the three bar icon at the top left
~ go to settings
~ select network
~then u tap the add network
A page like form will come up for u to fill in some address to it . Below is the picture of what to fill in the page , after filling it ,u tap save and automatically ur arbitrum wallet is ready .
Then bridging from layer 1 to layer 2, pls I will advise u use a laptop or desktop it’s far easier on them than ur smart phone .
Then u use bridge.arbitrum.io , connect ur wallet , make sure it’s on eth , then u select the wallet u are transferring from,(layer 1)
To AETH (layer 2) . I will advice if u want to swap pls swap 0.05 eth from layer 1 to layer 2 because if u pick 0.1 eth it might not swap except u go higher or lower ,but just select the amount that will allow the Deposit icon to come up .
After u have swapped ,ur AETH is ready.
Market place on Arbitrum
~ marketplace.treasure.lol
This is the main market for Arbitrum just like opensea ,( maybe there are other mkt places )
One thing to know is that every project has their minting site before listing in the market place .
I hope this thread 🧵 was helpful .
Like ❤️ And rt ♻️ If u enjoyed this thread
Then lastly :
List of Arbitrum maxis to follow and turn on notifications
~ @theNFTjosh
~ @0xDominic
~ @ArcanicNFT
~ @DannyOfCrypto
U can’t do it alone , u need to keep learning, unlearn and relearn .
Open ur heart to knowledge
Ty ❤️